Rpp - Bahasa Mandarin Sd Link

valleyviewlawns · Â 11-13-2021, 03:52 PM

I just received the NT530 scanner, and it is missing the BMW software, and after going through all of the steps in the manuals, FoxAssist will not load updates or software to the scanner. Just wondering if it is me, or is Foxwell having some sort of outage.

Sponsored Links

bcredliner · Â 11-13-2021, 04:22 PM

I have heard of some difficulty loading software on the NT530 and having difficultly with tech support. I have not heard any solutions other than tech support.

valleyviewlawns · Â 11-13-2021, 04:27 PM

Also, the FoxAssist software doesn't recognize my password when I run it each time. I have to go through the FORGET PASSWORD process everytime I open the application.

Sent from my moto g(7) optimo (XT1952DL) using Tapatalk

valleyviewlawns · Â 11-13-2021, 07:26 PM

I am at the mercy of tech support I think. I was able to register it earlier in FoxAssist, so now I can't register the scanner in FoxScanner. It says serial number error in FoxScanner when I try to register my scanner to start updates.

crystalworks · Â 11-14-2021, 10:05 PM

Quote:

Originally Posted by valleyviewlawns

I am at the mercy of tech support I think. I was able to register it earlier in FoxAssist, so now I can't register the scanner in FoxScanner. It says serial number error in FoxScanner when I try to register my scanner to start updates.

Where did you buy your unit? Yours came without vehicle software at all?

The 530 has to use Foxassist. The older units use Foxscanner afaik. I had to download Foxassist and register a new account on another Foxwell site. There are 2 different Foxeell websites associated with the older scanners vs the 530. Dumb setup, but did eventually work once I figured that out.

valleyviewlawns · Â 11-14-2021, 10:12 PM

I bought it direct from Foxwell. I have FoxAssist but the part that is supposed to be the link to the software updates and upgrades is a dead link. It opens a blank page.

Sent from my moto g(7) optimo (XT1952DL) using Tapatalk

crystalworks · Â 11-14-2021, 11:02 PM

Allright. Went ahead and connected mine (update available already) to test it out. Works for me so their servers are up.

So, when you log into FoxAssist you have everything blanked out. That's normal. If you have NOT activated your unit, do so following this: https://www.foxwelltool.com/service/...2019.7.31.html.

Basically it's the below.

1. Log in to Fox Assist
2. Connect your NT530. Wait for it to boot.
3. Now on the 530 navigate to "Update." The PC will detect a new USB device and FoxAssist will now fill in your serial number.
4. Click "Activate," you will get a success message
5. Click "Download" in FoxAssist and follow the above guide.

If you get an error message, you'll probably have to contact Foxwell, though I doubt you will. I got one (purchased on Ebay) and had to contact my retailer as they had registered the unit to themselves and downloaded the BMW software prior to shipping. They contacted Foxwell and released the serial number so I could register to my account.

valleyviewlawns · Â 11-15-2021, 01:21 AM

Here is what I see when I hook up the 530 to the PC, and click update on the 530. It already has the serial number on here, but there is no activate option anywhere.

Sponsored Links

Thread Tools